Smart Greenhouse

Hi freelancers Its a basic arduino based project This project mainly consist of four systems 1) Automatic Sunroof 1st system is automatic sunroof. i have made a sunroof and i have fit 2 DC motors for opening and closing the sunroof, i just need to connect these DC motors to the circuit and program it for opening and closing, later on we will decide what is the time for opening and closing of sunroof... This is the main idea,just open and close the sunroof because it is a smart greenhouse and we need to open and close the sunroof to control the sunlight falling down in the house. 2) Air Circulation System 2nd system is air circulation system, actually i have fitted to DC fans in the hardware. These fans are for air circulation or we can say for cooling inside the house. The idea is just i need to program these exhaust fans according to the temperature. when temperature exceeds a particular limit lets say 27 degree C then these fans should run automatically, also if temperature decreases this particular value below 27 then fans should switched OFF automatically. 3) Irrigation System 3rd system is irrigation system, its about a small pump working with DC system. it is fitted with small tank or a reservoir. I need to connect this DC pump to the circuit and programme it. I want it to be programmed so that i work for 10 minutes everyday automatically. i have already connected a small pipe from this pump to the plants. i will fit small plants inside the greenhouse and i will connect small pipes so it will goes from the tank to the plants. This pump should pump the water from tank to these plants inside the greenhouse. Another important thing that pump should work only when tank is already filled with water, if tank is empty then no need to work the pump because if there is not water in the tank and if pump will work then chances are there that it will burn as you know. 4) Lighting System The 4th system is simple lighting system, i will fit lights or LEDs inside the greenhouse which will switched OFF during day and switched ON in the night or dark Automatically, this is very simple and i think i will use LDR for this. So these are main 4 systems of complete greenhouse. I have also attached a document fully explaining the work. Requirements: I need Arduino Coding + Proteus Simulation Deadline is 2 weeks Budget is 30-40$