PIC18 jump from bootloader to aplication

€8-30 EUR

Closed

Posted

about 5 years ago

€8-30 EUR

Paid on delivery

I have a little bootloader that flash a new firmware into the top memory, when it finish i make Reset() (LINE 197) and aplication runs fine , the problem is when I turn off the circuit, it start again from bootloader I make a eeprom variable set to 1 if flash was sucessfuly, so then if eeprom == 1 I perform a reset() (LINE 79) to force to start aplication but doesn't work PIC18F26K22 made in MPLAB X 4.20, i don't accept another version

C Programming

Electrical Engineering

Electronics

Firmware

Microcontroller

Project ID: 19260715

About the project

4 proposals

Remote project

Active 5 yrs ago

Looking to make some money?

Email address

Benefits of bidding on Freelancer

Set your budget and timeframe

Get paid for your work

Outline your proposal

It's free to sign up and bid on jobs

4 freelancers are bidding on average €34 EUR for this job

@Hafeez143

Hi, I found that in your code at line 198 you are calling GotoAppUser(); after calling Reset(); but this is not done at line 79. Regards, Hafeez

€50 EUR in 1 day

4.9

(13 reviews)

5.9

@gsa5b06f37877085

Hello, I am an electromechanical and electronic technician, and I only have the thesis to be an electronic engineer. I work in an electrical testing laboratory, under international standards, im work here for more than a year ago. I have experience in electronics design. If you want to know something else, do not hesitate to contact me I think it could be of great help for your project. I am already at your disposal. regards

€30 EUR in 10 days

5.0

(2 reviews)

2.3

@jayanthd2k12

I have 17 years experience with electronics and 8 years of experience in embedded electronics. I have worked with 8051, PIC, AVR, PIC24, dsPIC, PIC32, STM32, Tiva, Stellaris, LPC, MSP430, FT90x, Arduino, ChipKit, RaspBerry Pi controllers. I have all the necessary tools (software, hardware, and test equipment) like Keil, mikroC, mikroBasic, mikroPascal, CodeVisionAVR and much other software. I have many development boards and modules. I have a lot of test equipment to test and debug the codes like Oscilloscope, Logic Analyzer, etc,... I can provide you a working professional code within 1 hour. You can contact me at jayanthd2k12(at)gmail(dot)com In the above replace (at) with @ and (dot) with .

€22 EUR in 1 day